Filter
Top Products
21
3.
Remove the card thickness switching plate and
invert the direction.
Move the plate back into position securely and tighten
the screw.
4.
Checking card feed
Set a few cards on the card tray.
Turn the roller drive gear in the arrow direction, and
check that only one card is fed at a time.
0.25
0.76
0.76
0.25
Roller drive gear
The card having a thickness value
written on this side is discharged.
Memo
If the card thickness is not switching properly, or
cards cannot be fed because of the dirt on the feed
roller,
appears on the LCD panel.
Check the proper setting of the card thickness
plate, and clean the feed roller (see p.40).
JAM (Hopper)
0.76
0.25
Switching the card thickness
Depending on the material, some 0.25mm thick cards
may not be suitable for printing. Consult your dealer
regarding the materials and specifications of the card
before purchasing.
WARNING
ⅷ
Before switching the thickness, turn off the
printer and the devices connecting to the
printer, and take off their power plugs from
the outlet to prevent an electric shock.
CAUTION
ⅷWhen switching the card thickness, be
careful not to remove the screws except
those instructed. Removing uninstructed
screws may cause injuries or a
malfunction of the printer.
1.
Remove the blue securing screw.
Do not remove the screws other
than blue ones. Removing other screws may cause a
malfunction of the printer.
2.
Remove the card thickness switching plate.
Pull the plate up while pressing the left and right knobs
toward the center.
Injury
Electric shock
CAUTION
Plate securing screw
0.25
0.76
Thickness
switching plate