Filter
Top Products
31
(to the next page)
>Retransfer>
>>Media Type
>>Temp.Level
>>Speed (Front)
>>Speed (Back)
Std(1000/roll):0
0(Standard)
-2
-2
ENTER
ENTER
ENTER
ENTER
RESET
ENTER
MENU
MENU
MENU
MENU
EXIT
EXIT
EXIT
EXIT
ENTER
EXIT
Retransfer mode setting
Change settings according to the retranfer film and
card used.
(The electronic beep sounds .)
Set the retransfer temperature.
8 gradations can be set
(from –5 to +2, the larger the value the higher the temperature)
Set the reverse retransfer speed:
5 gradations can be set
(from –2 to +2, the higher the value the faster the speed.)
Exit user mode
If initialization is not carried out, the temperature setting will have no effect on the printer.
Set the retransfer speed:
5 gradations can be set
(from –2 to +2, the larger the value the faster the speed)
to select the
setting and
press
to select the
setting value
and press
to select the setting
value and press
to select the
setting value
and press
Press
to save.
Press
to save.
Press
to save.
Press
to save.
ⅷ Retransfer may be not performed well depending on the
cards. Increase the temperature level step by step until the
card can be printed clearly.
ⅷ Partial incompletions may occur depending on the cards
during retransfer. The performance is increased as the
value is lowered. Specify the value mainly on the retransfer
roller temperature setting and use the speed setting for fine
adjustments.
ⅷ Double-sided printing results in a warp depending on the
cards. Change the speed to correct it.
* After exiting the
user mode, press
and then
press
to initialize.
(The electronic beep sounds .)
(The electronic beep sounds .)
(The electronic beep sounds .)
Set retransfer film
Set film type
Two types of frame settings (1000 frames per film,
250 frames per film)
ⅷ In addition to setting the number of frames, change the
setting when using special films (not yet available). To use
these films, the firmware of this machine needs upgrading.
Please consult your dealer.