Filter
Top Products
Step 2: Update the Frimware of your SC-T35 Thin Client
To update rmware for your SC-T35 thin client, please do the following:
1. In the Power-o state (the Power LED is o), plug your USB ash drive into a USB port on the front panel
of your SC-T35, and ensure that you have made power connection and connected a keyboard, mouse, and
monitor to your SC-T35 thin client.
NOTE
t Please connect the monitor to the VGA or DVI-I port for rmware update.
2. In Power-o state (the Power LED is o), connect a monitor to your client, long press the power button about
6 to 8 seconds, then release the power button to enter ViewSonic Thin Client Menu.
ViewSonic Thin Client Menu
Normal Mode
Safe Mode
Reset Mode
Firmware update
Reboot
Shutdown
NOTE
t Six options are available on ViewSonic Thin Client Menu: Normal Mode, Safe Mode,
Reset Mode, Firmware update, Reboot, and Shutdown. See the table below for
the description of each option:
Menu Option Description
Normal Mode Boots up your SC-T35 as the normal startup procedure.
Safe Mode Clears and resets the current screen resolution setting.
Reset Mode Resets your SC-T35 to the factory default.
Firmware update 8SGDWHV¿UPZDUHIRU\RXU6&7
Reboot Reboots your SC-T35.
Shutdown Shuts down your SC-T35.
3. Use arrow keys on the keyboard to select Firmware update, and then press Enter to continue.
4. ViewSonic Thin Client Recovery System is launched with a message prompting for conrmation.
5. Use arrow keys on the keyboard to select Yes , and then press Enter to continue.
6. A new screen appears prompting you to select the source for rmware update.