Filter
Top Products
SETTING THE SYSTEM CONFIGURATION
XEROX DOCUPRINT 4050/4090 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 4-47
Specifying the output configuration
This section describes the procedures you use to specify output tray
configurations for your system. (For an explanation of the buttons on
these windows, refer to the “Buttons” section in the “Introduction to
the graphical user interface” section.)
When you specify the output configuration, you specify one or more
stacker trays for each IPDS output bin specified in a print job. The
printer delivers the printed output to the trays specified for a given
IPDS bin; it stops and notifies you to unload output only when all
those trays are full.
Note: When configuring stacker groups, the printer feeds from any
of the stackers in the group, with no particular order to follow. In other
words, the printer will not necessarily start with the lowest numbered
stacker in the group.
The ability to configure multiple output trays to receive a print job
greatly reduces interruptions for unloading output.