Filter
Top Products
SETTING THE SYSTEM CONFIGURATION
4-50 XEROX DOCUPRINT 4050/4090 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
2. Make any desired changes in the fields described below.
• Bin Selection Mode — Specifies how the IPS will
determine the bin to which the job will be delivered.
The option buttons are:
— Use Default Bin — Output will be delivered to the bin
you designate from the Default Bin Number pull-down
menu.
— Allow Host Control — The host handles bin
selection, and the system uses the bin you selected to
correspond to the IPDS Bin number.
Note: If you are enabling DFA, select “Allow Host Control”
for the bin selection mode.
• Default IPDS Bin — Specifies the number for the bin to
which output will be delivered if “Use Default Bin” is selected
from the Bin Selection Mode menu, or if a bin number is not
specified by a job on the host.
Note: Output is delivered to the default bin if one of the
following conditions applies:
—“Use Default Bin” is selected as the Bin Selection
Mode.
—“Allow Host Control” is selected as the Bin Selection
Mode, but there is no OUTBIN statement for the host.
—“Allow Host Control” is selected as the Bin Selection
Mode, but the OUTBIN specified is greater than the
number of stackers.
Figure 4-39. Default IPDS Bin pull-down menu
Note: The IPDS Bin 1 row is set to Sample Tray, and
cannot be changed. If you want your output to be delivered
to the stacker trays, you must select something other than
Bin 1 for the Default Bin Number.
• (DFA systems only) Check the “Finishing” box then click the
Finishing Attributes button to specify the finishing attributes.
Refer to “Specifying finishing attributes” later in this section.
• (Systems with a stitcher only) Check the “Stitching” box
then click the Stitching Attributes button to specify the
finishing attributes. Refer to “Specifying stitching attributes”
later in this section.