Filter
Top Products
SETTING THE SYSTEM CONFIGURATION
XEROX DOCUPRINT 4050/4090 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM 4-11
Setting optional processing parameters
You can set processing parameters for your system as follows:
1. Select Optional Processing Parameters from the Configuration
pull-down menu.
2. On the Optional Processing Parameters screen (refer to the
next page for an illustration), identify the parameters you want
to set.
• Number of imagers — Specifies how many imagers to run.
An imager should be added for each CPU on the system.
• Trace drawing commands — Enables or disables tracing
of the IPDS commands sent from PSF. These commands
result in drawing commands for the imagers.
Checking this option will degrade performance.
• Ignore black areas — Enables or disables the WCB option.
This option removes large areas of black from IM images to
save printer consumables.
• Use replicate and trim — Enables or disables the
Replicate and Trim option. This option is used to image
large areas by using a small area pattern supplied by the
host, and replicate the pattern to fill the large area in a tiling
manner. Enabling this option reduces the transmission time
for image data from PSF to the IPS printer. By default, this
parameter should be enabled.
• Use alternate printer model number — Specifies the
printer model sent by the IPS printer to PSF during a Sense
Type and Model (STM) response. The model number must
consist of four numeric characters.
• Alternate Markform — Enables or disables the Alternate
Markform option. This option prints a printer specific mark
on the end banner sheets. Enabling this option results in a
Xerox logo. By default, this parameter is set to print a black
bar on the end banner sheets.
• Apply darkening — Enables or disables the darkening
option. This option uses a pixel-doubling algorithm.
3. For each parameter, select the checkbox and enter the
information on the right, if applicable.
4. When all parameters are set, click Apply.