Filter
Top Products
XES COMMAND LANGUAGE MODE
If a graphic window has been stored in the printer’s memory, it
remains until you power off the printer, switch emulations, or
perform a reset.
Note: If the printer receives graphic data that is incomplete,
e.g. the data has fewer bytes than the window size, the next
Form Feed command may be ignored, causing unpredictable
results.
Origin and page orientation
The graphic window’s origin is always the corner of the window
closest to the upper left hand corner of the page. It is
independent of page origin, feed direction, or paper size. (See
figure 2-19).
Since window boundaries cannot be seen on your host computer
screen, you may want to sketch an outline of the window on
paper, then enter the commands based on the measurements in
your sketch.
Figure 2-19. Graphic windows for portrait and landscape
printing
Placement on the page
You can define a window so that part of it is located either
above the top of the page or below the bottom of the page. If
you place an entire window off the page, nothing is printed and
an error message appears on the XES Summary Sheet.
You can place windows and copied windows on top of each
other on the page. However, this type of page complexity may
slow the processing speed of the printer.
2-80 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE