Filter
Top Products
XES COMMAND LANGUAGE MODE
When the printer is powered on, units of measure are set at
1/60th inches automatically. The Reset command, which clears all
settings, also returns the units to 1/60 inches. Thus, at the start of
a job, if you want to use 1/60 inch for your unit of measure, you
need not use the Units command.
If your job requires calculations for absolute or relative placement
of text, or for nongraphic lines, all of which are measured in units
of one pixel or 1/300 inch, you may want to select Units—1/300
for margins and tabs as well.
Appendix B, “Conversion tables for units of measure,“ lists 1/60
and 1/300 inch equivalents for inches, millimetres, 10-pitch
characters, and 12-pitch characters.
Units—1/60
Purpose Sets five pixels (1/60 inch or .42 millimetres) as the unit of
measure for margins and tabs.
Syntax
Ezg
Where to place it Before the margins or tabs command to which it applies.
Units—1/300
Purpose Sets one pixel (1/300 inch or .08 millimetres) as the unit of
measure for margins and tabs.
Syntax
Ezf
Where to place it Before the margins or tabs command to which it applies.
2-38 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE