Filter
Top Products
XES COMMAND LANGUAGE MODE
The mode change command
The mode change command resets your 4213, enabling it to
accept printing commands in the desired emulation mode.
Note: Unpredictable results such as loss of data may occur if the
mode change command is not entered with valid parameters.
Send the following commands to your printer, preferably in the
form of a test file:
PostScript Emulation
=MCK=EMULATE/POSTSCRIPT/END L
This information tells your printer to begin printing in the
PostScript emulation mode.
HP PCL Emulation
=MCK=EMULATE/PCL/END L
This information tells your printer to begin printing in the HP PCL
emulation mode.
XES Emulation
=MCK=EMULATE/XDCS/END L
This information tells your printer to begin printing in the XES
emulation mode. You can replace “XDCS” with either “XES” or
“2700” in the mode change command to enter the XES
emulation mode.
Note: A space is required immediately after the =MCK=
sequence. A line ending following the END keyword completes
the command.
The reset command
The reset command resets the 4213 laser printer, restoring it to
the default settings that were in effect at the last power off cycle.
Send the following command to your printer, preferably in the
form of a text file:
Reset
=MCK=RESET/END L
2-2 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE