Filter
Top Products
XES COMMAND LANGUAGE MODE
Figure 2-36. Close up of data monitor printout
Note the following about the data monitor printout:
• The characters printed on the right half of the printout are
either ISO or EBCDIC characters. The data monitor always
uses the translation table for EBCDIC data, regardless of the
language selected. If ASCII encoding is selected, ISO
characters are printed.
• The Page number refers to the pages of the printout, not of
the transmitted job.
(Those in figures 2-35 and 2-36 are ISO).
See the Xerox 4213 User Guide, Diagnostics chapter for more
information on using the data monitor.
Character codes on the Xerox 4213
For the printer to print the characters in a font, each character is
assigned a hexadecimal code. The code assigned to a character
may vary, according to the data encoding system (ASCII,
EBCDIC, or ISO), the language selection, and the characters
available in the font selected.
When the host sends the printer a hexadecimal code for a
character, the printer knows which character to print because of
the assigned table linking the code to each character.
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE 2-107