Filter
Top Products
XES COMMAND LANGUAGE MODE
%1 The percent of the pie to be taken up by the first
pie slice. The total of all percentages must add up
to 100.
/ A slash separates this percentage from the fill
pattern number and offset value. Both the fill
pattern and offset value are optional.
F1 The number of the fill pattern selection (refer to
Graphic Fill).
O1 The offset value, if the slice is to be offset from
the centre; the distance from the centre point of
the pie to the narrowest point in the pie slice.
%n/Fn/On Parameters for all remaining pie slices: percentage,
fill pattern, and offset value, respectively.
L Line end.
More As with the graphic arc, the pie is drawn in a counterclockwise
direction.
Remember that the slices are defined in percentages, not angles.
Percentages must total 100%.
If the sum of the pie slice is less than 100%, the pie is not
closed. If the sum of the pie is greater than 100%, all slices
above 100%, whether whole or partial, are ignored, and the pie
is not closed. An error message appears on the Summary Sheet.
Note It is not recommended to use zero as a percentage.
Example To create the pie chart in figure 2-34:
• Drawn with a line five pixels thick
• At coordinates 450,450 in the graphic window
• With a radius of 285 pixels
• Consisting of five slices:
— Slice 1 is 20% and is filled with pattern 10; it is offset by
10 pixels.
— Slice 2 is 30% and is filled with pattern 13; it is offset by
10 pixels.
— Slice 3 is 10% and is filled with pattern 2; it is offset by
50 pixels.
2-104 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE