Filter
Top Products
XES COMMAND LANGUAGE MODE
Graphic Box
Purpose Draws a rectangle by defining two sets of right angles. Two
coordinates define the diagonal corners. The printer then fills in
the vertical and horizontal lines for the top, bottom, and sides.
Syntax
EgbT;X1,Y1,X2,Y2L
gb Instruction to create a graphic box.
T Line thickness of the figure. The maximum value
is 16 pixels. No error message is generated if a
greater value is entered.
The width is distributed equally on the inside and
outside of the box. The 4213 adjusts the width if
it cannot be distributed equally.
; The semicolon is required. If it is omitted, the
command is ignored. Commas separate the other
variables.
X1,Y1 The coordinates of the first of two points that
make up diagonally opposite corners. X
1 is the
horizontal distance from the left edge of the
graphic window. Y
1 is the vertical distance from
the top edge of the graphic window.
X2,Y2 The coordinates of the second of two points.
L Line end.
More If a value for X
1 is omitted, the printer will use the x-coordinate
from the current graphic position. If this box is the first graphic
drawn in the window, the x-coordinate of the window origin is
substituted as the x-value of the corner.
If a value for Y
1 is omitted, the printer will use the y-coordinate
from the current graphic position. If this box is the first graphic
drawn in the window, the y-coordinate of the window origin is
substituted as the y-value of the corner.
Example To create the box in figure 2-30:
• Drawn with a line seven pixels thick
• The coordinates of one corner set at 75,225 in the graphic
window
2-98 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE