Filter
Top Products
LJ SERIES 2D EMULATION
Fill Rectangular Area
Purpose The Fill Rectangular Area command prints the rectangle defined
by the Vertical and Horizontal Rectangle Size commands and
specifies whether it is to be filled with shading, one of the fill
patterns, or solid black. For solid black fill, the Area Fill ID
command is not required. For shading or a fill pattern, the Area
Fill ID command must be used ahead of the Fill Rectangular Area
command.
The rectangle is printed with its top left corner at the current
cursor position, which is unaffected by the command. The
command ignores text boundaries, but any part of the rectangle
falling outside of the printable area is not printed.
Syntax
E
*c#P
Hex 1B 2A 63 # 50
Dec 27 42 99 # 80
where # is a value from table 3-14.
Table 3-14. Fill types for rectangular areas
# Rectangle Fill Type
0 Solid Black Fill
2 Shading
3 Pattern
Examples of filled rectangles
Example 1 To print a 2- by 3-inch rectangle, enter the following commands:
1.
E
*p300x300Y
(Moves cursor one inch down and one inch across)
3-58 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE