Filter
Top Products
Page 28 Web Print Manager Tool User Guide
network, the Web PMT will be completely unusable. For the Synergix
Print Systems 8825, 8830, 8850 and 510dp, you can use the Printer
Control Panel to undo this setting. For the Synergix Print Systems 8855
and 721p, you will need to upload a recovery file to the Controller through
the serial or parallel port.
3. Netmask - These fields contain the value that the printer will use for its IP
sub-net mask. The format is the same as the Ethernet TCP/IP Address.
4. Ethernet TCP/IP Address - These four fields contain the IP address of the
Network Interface Card on the printer’s controller. The address is of the form
"w.x.y.z" where the range for w, x, and y is 0-255 and z is 0-254.
5. Ethernet TCP/IP Gateway - These fields contain the IP address of the device
the printer will use as the gateway or router. The format is the same as the
Ethernet TCP/IP Address.
6. For the Synergix Print Systems 8855, 721p, and Synergix Color Print System
X2 TECH, BEFORE pressing the Update Printer button, click on the indicated
hypertext link to save a TCP/IP Recovery file. If the Web PMT becomes
unusable, you can send this recovery file to the Controller through the serial
or parallel port. For the 8825/8830/8850/ 510dp Printers, you MUST make a
written record of these settings BEFORE clicking the Update Printer button.
NOTE: After modifying the IP Address, Subnet Mask, or Gateway, you should
reboot (power off, then power on) the Controller to use the new settings.
IPX/SPX Page (8830/8825 printers only)
Navigation: PRINTER DEFAULTS > NETWORK > IPX/SPX
If you entered the printer password in the Session Setup, you can change the
Novell IPX/SPX parameters in the printer if you have the network interface card.
These parameters are described below:
1. Enabled - Click on this check box to enable/disable IPX/NDS on the
printer.
2. IPX Frame Type - Click on this list box to select the IPX frame (link level)
protocol. The possible values are AUTO, 802.3, 802.2, SNAP and
ETHERNET2.
3. IPX Queue Scan Rate - Enter the query interval in integer seconds (0-
255). This controls the frequency with which NetWare file servers are
queried for print jobs.
4. Bindery Mode (Novell 3.XX) - Click on this radio button to enable the
Bindery Mode; the NDS Mode will be disabled.