Filter
Top Products
Web Print Manager Tool User Guide Page 45
4. Margins - Click on this drop box to select from a list of the available
margin override settings. Available options are Always Off, USE
PROGRAM SETTING. Default is USE PROGRAM SETTING
5. Crossfold - Click on this drop box to select from a list of the available
crossfold override settings. Available options are Always On, Always Off,
USE PROGRAM SETTING. Default is USE PROGRAM SETTING
6. Title Block Location - Click on this drop box to select from a list of the
available title block override settings. Available options are Don't Care,
Upper Left, Upper Right, Lower Left, Lower Right. Default is Don't Care
7. Output Bin - Click on this drop box to select from a list of the available
output bin override settings. Available options are Don't Care, Bin 1
through Bin 13, Fanfold, Bypass. Default is Don't Care.
8. Intelligent title block –
For folding documents with title blocks in standard corners: If you selected
an incorrect title block location for the fold style, checking the Intelligent
Title Block box will adjust the location of the title block for proper folding.
For folding documents with title blocks that are not in an expected
standard corner: Leave the Intelligent Title Block box unchecked.
9. Press the Update Printer button to update the specified parameter
changes in the printer.
Justification Page
Navigation: PRINTER DEFAULTS > PROCESSING DEFAULTS > Justification
If you entered the printer password in the Session Setup, you can change the
default printer parameters for justification in the X and Y directions as follows:
1. Using the Absolute and Relative radio buttons, you may independently
specify X and Y justification in absolute dimensions or relatively.
• X - the left margin position of the printed image on the page.
• Y - specifies the top margin position of the printed image on the page.
Relative - Click on this radio button to select relative justification for
either X or Y. If Relative is selected for either X or Y, click on the
corresponding list box to select the one of the relative values.
Absolute - Click on this radio button to select absolute dimensions for
either X or Y. If Absolute is selected for either X or Y, in the
corresponding text box enter the desired value (0 to 2540 mm, or 0.0
to 100.0 inches). The units for absolute dimensions are specified on
the Set Display Units page of the UTILITIES group of the Printer
Defaults Side Menu.
2. Press the Update Printer button to update the default justification
parameters in the printer.