Filter
Top Products
Configure Port 9100 (Raw Printing)
WorkCentre 7425/7428/7435
System Administrator Guide
51
Configure Port 9100 (Raw Printing)
1. Open your Web browser and enter the IP address of the printer in the address field. Press Enter to
open CentreWare Internet Services.
2. Click the Properties tab.
3. Enter the system administrator User Name and Password (default admin, 1111) if prompted.
4. Click the Connectivity folder on the left, then the Protocols folder.
5. Select Port 9100 in the directory tree.
6. The available selections include:
• TCP Port Number: The default value is 9100. This typically does not need to be changed.
• End of Job Timeout: Enter a Time Out value for jobs being sent to the printer through this
Port. This is the length of time that the Controller will wait for an end of job command before
printing the current job.
• TBCP Filter: A check box (displayed when PostScript is enabled).
7. Click the Apply button to accept changes, or the Undo button to return settings to their previous
values.
Note: Setting changes are not applied until you restart the printer.
Note: If Port 9100 is not displayed in the Properties Tab directory tree, click the Port Status in the
Connectivity folder in the tree. In the Port Status table, use your mouse to place a check mark in the
check box on the Port 9100 line. Click the Apply button, then click the Reboot button (always available
on the Status Tab) to remotely reboot the printer.