Filter
Top Products
8 Zebra ZXP Series 7 Card Printer User’s Manual P1036101-002
2: Installation and Setup
Loading Cards
Loading Cards
Step 1. Remove the wrapping from the card stack.
Step 2. Holding the card stack by the sides (do not touch the print surfaces), hold it
vertically against a flat surface such as a desktop. If the stack is too thick for your
hand to hold it comfortably, use about half a stack at a time.
Step 3. Push the stack back and forth to an angle of about 45
° from vertical, so as to separate
all of the cards.
Step 4. Restore the card stack to its original squared-off condition.
Caution • DO NOT bend cards or touch print surfaces as this can reduce print quality.
The surface of the cards must remain clean and dust free. Always store cards in an
enclosed container. Ideally, use cards as soon as possible after unwrapping.
Note • Static charges and edge burrs from the card die-cutting process can render individual
cards stuck together with significant adhesion force. These cards must be physically
separated from each other before inserting into the feeder; if not separated, feeding or
printing problems may occur.