Filter
Top Products
E: Smart Card Options
P1036101-002 Zebra ZXP Series 7 Card Printer User’s Manual 189
External Contact Station Interface
When a command to the printer interface sends a card to the External Contact Station, the
printer connects the External Contact Station to the female DB-9 connector on the rear of
the printer.
An attached external Smart Card Programmer can be used to program Smart Card chips. The
following table shows the Smart Card Contact Points.
DB-9 Pin Connections
Pin Smart Card Contact Points Pin Smart Card Contact Points
1 C1 (VCC) 6 C6 (Vpp)
2 C2 (Reset) 7 C7 (I/O)
3 C3 (Clock) 8 C8 (RFU)
4C4 (RFU)
9
(GND when chip
is at station)
5 C5 (GND)
DB-9 Connector location for
External Contact Station