Filter
Top Products
2: Installation and Setup
Connecting Power
P1036101-002 Zebra ZXP Series 7 Card Printer User’s Manual 31
Connecting Power
Step 1. Place the Printer’s power switch in the OFF ( )position.
Step 2. Depending on your local AC voltage, plug the appropriate power cord into the
Printer’s power connector and a grounded AC power source connection.
Electric Shock • Limit AC power supplied to the Printer to 90V~264V, 47-63Hz (50-60Hz
nominal). Limit excess current draw to 16 amps or less, using an associated circuit
breaker or other such device. Never operate the Printer in a location where operator,
computer, or printer can get wet. Personal injury could result. The Printer must be
connected to an earthed electrical power source and properly protected against electrical
surges and grounding faults; the electrical reliability of the Printer is based on the
reliability of the main power source and the earth connection.
The Printer’s power supply is an internal unit that can only be serviced or replaced by
trained and authorized personnel.
1
2
(OFF)
Important • DO NOT switch the printer on.