Filter
Top Products
Chapter 5 Quick Setup
ZyWALL USG 1000 User’s Guide
81
Authentication
Type
Use the drop-down list box to select an authentication protocol for
outgoing calls. Options are:
CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when
requested by this remote node.
CHAP - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
User Name Type the user name given to you by your ISP. You can use
alphanumeric and -_
@$./ characters, and it can be up to 31
characters long.
Password Type the password associated with the user name above. Use up to 64
ASCII characters except the [] and ?. This field can be blank.
Retype to
Confirm
Type your password again for confirmation.
Nailed-Up Select Nailed-Up if you do not want the connection to time out.
Idle Timeout Type the time in seconds that elapses before the router automatically
disconnects from the PPPoE server. 0 means no timeout.
PPTP
Configuration
This section only appears if the interface uses a PPPoE or PPTP
Internet connection.
Base Interface This displays the identity of the Ethernet interface you configure to
connect with a modem or router.
Base IP
Address
Type the (static) IP address assigned to you by your ISP.
IP Subnet
Mask
Type the subnet mask assigned to you by your ISP (if given).
Server IP Type the IP address of the PPTP server.
Connection ID Enter the connection ID or connection name in this field. It must
follow the "c:id" and "n:name" format. For example, C:12 or N:My
ISP.
This field is optional and depends on the requirements of your DSL
modem.
You can use alphanumeric and -_
: characters, and it can be up to 31
characters long.
WAN Interface
Setup
WAN Interface This displays the identity of the interface you configure to connect
with your ISP.
Zone This field displays to which security zone this interface and Internet
connection will belong.
IP Address This field is read-only when the WAN interface uses a dynamic IP
address. If your WAN interface uses a static IP address, enter it in this
field.
Table 10 WAN and ISP Connection Settings (continued)
LABEL DESCRIPTION