Filter
Top Products
Chapter 56 Troubleshooting
ZyWALL USG 1000 User’s Guide
886
The packet capture screen’s File Size sets a maximum size limit for the total
combined size of all the capture files on the ZyWALL, including any existing
capture files and any new capture files you generate. If you have existing capture
files you may need to set this size larger or delete existing capture files.
The ZyWALL stops the capture and generates the capture file when either the
capture files reach the File Size or the time period specified in the Duration field
expires.
My earlier packet capture files are missing.
New capture files overwrite existing files of the same name. Change the File
Suffix field’s setting to avoid this.
56.1 Resetting the ZyWALL
If you cannot access the ZyWALL by any method, try restarting it by turning the
power off and then on again. If you still cannot access the ZyWALL by any method
or you forget the administrator password(s), you can reset the ZyWALL to its
factory-default settings. Any configuration files or shell scripts that you saved on
the ZyWALL should still be available afterwards.
Use the following procedure to reset the ZyWALL to its factory-default settings.
This overwrites the settings in the startup-config.conf file with the settings in the
system-default.conf file.
Note: This procedure removes the current configuration.
If you want to reboot the device without changing the current configuration, see
Chapter 54 on page 865.
1 Make sure the SYS LED is on and not blinking.
2 Press the RESET button and hold it until the SYS LED begins to blink. (This
usually takes about five seconds.)
3 Release the RESET button, and wait for the ZyWALL to restart.
You should be able to access the ZyWALL using the default settings.