Filter
Top Products
Appendix A Log Descriptions
ZyWALL USG 1000 User’s Guide
952
Interface %s connect
failed: MS-CHAP
authentication
failed.
MS-CHAP authentication failed (the server must support MS-
CHAP and verify that the authentication failed, this does not
include cases where the server does not support MS-CHAP).
%s: interface name.
Interface %s connect
failed: CHAP
authentication
failed.
CHAP authentication failed (the server must support CHAP
and verify that the authentication failed, this does not include
cases where the server does not support CHAP). CHAP:
interface name.
Interface %s is
connected.
A PPP or AUX interface connected successfully. %s: interface
name.
Interface %s is
disconnected.
A PPP or AUX interface disconnected successfully. %s:
interface name.
Interface %s connect
failed: Peer not
responding.
The interface’s connection will be terminated because the
server did not send any LCP packets. %s: interface name.
Interface %s connect
failed: PAP
authentication
failed.
PAP authentication failed (the server must support PAP and
verify verify that the authentication failed, this does not
include cases where the server does not support PAP). %s:
PPP interface name.
Interface %s connect
failed: Connect
timeout.
A PPPOE connection timed out due to a lack of response from
the PPPOE server. %s: PPP interface name.
Interface %s create
failed because has no
member.
A bridge interface has no member. %s: bridge interface
name.
"Interface cellular
Application Error Code
%d\n.
The listed error code (%d) was generated due to an internal
cellular interface error.
"An error [%d]
occurred while
negotiating with the
device in %s. Please
try to remove then
insert the device.
The listed error code (%d) happened when the ZyWALL
attempted to negotiate with the cellular device installed in (or
connected to) the listed slot (%s). Remove and reinstall the
device.
"Unable to negotiate
with the device in %s.
Please try to remove
then insert the
device.
The ZyWALL could not negotiate with the cellular device
installed in (or connected to) the listed slot (%s). Remove
and reinstall the device.
"Unable to configure
the selected frequency
band to the device in
%s. Please try to
remove then insert the
device.
The ZyWALL failed to set the cellular device installed in (or
connected to) the listed slot (%s) to use the frequency band
you configured. The cellular device may not support the band
or you may need to try removing and reinstalling the device.
"PIN code is required
for inteface
cellular%d. Please
check the PIN code
setting.
The PIN code configured for the listed cellular interface (%d)
is incorrect or missing.
Table 284 Interface Logs (continued)
LOG MESSAGE DESCRIPTION