Filter
Top Products
Chapter 9 Static Route
AMG1312-T Series User’s Guide
133
9.1.1 What You Can Do in the Static Route Screens
•Use the Static Route screens (Section 9.2 on page 133) to view and configure IP static routes
on the AMG1312-T Series.
•Use the IPv6 Static Route screens (Section 9.3 on page 134) to view and configure IPv6 static
routes on the AMG1312-T Series.
9.2 The Static Route Screen
Use this screen to view the static route rules. Click Network Setting > Static Route to open the
Static Route screen.
Figure 58 Network Setting > Static Route
The following table describes the labels in this screen.
9.2.1 Static Route Add/Edit
Use this screen to add or edit a static route. Click Add new Static Route Entry in the Routing
screen or the Edit icon next to the static route you want to edit. The screen shown next appears.
Table 39 Network Setting > Static Route
LABEL DESCRIPTION
Add new static
route
Click this to configure a new static route.
# This is the number of an individual static route.
Destination IP This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Metric This is the number of transmission hops between this AMG1312-T Series and the
destination.
Modify Click the Edit icon to go to the screen where you can set up a static route on the
AMG1312-T Series.
Click the Delete icon to remove a static route from the AMG1312-T Series. A window
displays asking you to confirm that you want to delete the route.