Filter
Top Products
Chapter 10 Quality of Service (QoS)
AMG1312-T Series User’s Guide
139
10.3.1 Adding a QoS Queue
Click the edit icon in the Queue Setup screen to configure a queue.
Figure 65 Queue Setup: Edit
The following table describes the labels in this screen.
Rate Limit This shows the maximum transmission rate allowed for traffic on this queue.
Modify Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent rules move up by one
when you take this action.
Table 44 Network Setting > QoS > Queue (continued)
LABEL DESCRIPTION
Table 45 Queue Setup: Edit
LABEL DESCRIPTION
Active Select to enable or disable this queue.
Name Enter the descriptive name of this queue.
Interface Select the interface to which this queue is applied.
This field is read-only if you are editing the queue.
Priority Select the priority level (from 1 to 3) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to higher priority
queues gets through faster while traffic in lower priority queues is dropped if the network is
congested.
Weight Select the weight (from 1 to 8) of this queue.
If two queues have the same priority level, the AMG1312-T Series divides the bandwidth
across the queues according to their weights. Queues with larger weights get more
bandwidth than queues with smaller weights.
Rate Limit Specify the maximum transmission rate (in Kbps) allowed for traffic on this queue.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.