Filter
Top Products
Chapter 9 Static Route
AMG1312-T Series User’s Guide
134
Figure 59 Network Setting > Static Route Add/Edit
The following table describes the labels in this screen.
9.3 IPv6 Static Route
Use this screen to view the IPv6 static route rules. Click Network Setting > Static Route > IPv6
Static Route to open the IPv6 Static Route screen.
Figure 60 Network Setting > Static Route > IPv6 Static Route
The following table describes the labels in this screen.
Table 40 Network Setting > Static Route Add/Edit
LABEL DESCRIPTION
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Metric Enter the number of transmission hops (routers) that need to cross from the AMG1312-T
Series to the destination.
OK Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 41 Network Setting > Static Route > IPv6 Static Route
LABEL DESCRIPTION
Add new static
route
Click this to configure a new IPv6 static route.
# This is the number of an individual static route.