Filter
Top Products
Chapter 25 Remote Management
AMG1312-T Series User’s Guide
213
25.3 The Telnet Screen
You can use Telnet to access the AMG1312-T Series’s command line interface. Specify which
interfaces allow Telnet access and from which IP address the access can come.
Click Maintenance > RemoteMGMT > Telnet tab to display the screen as shown.
Figure 122 Maintenance > RemoteMGMT > Telnet
The following table describes the labels in this screen.
25.4 The FTP Screen
You can use FTP (File Transfer Protocol) to upload and download the AMG1312-T Series’s firmware
and configuration files. Please see the User’s Guide chapter on firmware and configuration file
maintenance for details. To use this feature, your computer must have an FTP client.
Table 90 Maintenance > RemoteMGMT > Telnet
LABEL DESCRIPTION
Server Port This displays the service port number for accessing the AMG1312-T Series. If the number
is grayed out, it is not editable.
Server Access Select the interface(s) through which a computer may access the AMG1312-T Series
using this service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule. See Firewall Section
on page 168 for information on configuring firewall rules.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
AMG1312-T Series using this service.
Select All to allow any computer to access the AMG1312-T Series using this service.
Choose Range to just allow the computer(s) with an IP address in the range that you
specify to access the AMG1312-T Series using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.