Filter
Top Products
ES-2024 Series User’s Guide
225 Chapter 32 Configuration Mode Commands
Syntax:
no ip route <ip> <mask> inactive
where
An example is shown next.
• Enable the IP route with the IP address of 192.168.11.1 and subnet mask of
255.255.255.0. This IP route must have already been created and made inactive prior to
re-enable command being applied.
32.5.4 Other Examples of no Commands
In some cases the no command can disable a feature, disable an option of a feature or disable a
feature on a port-by-port basis.
32.5.4.1 no trunk
Syntax:
no trunk <T1|T2|T3>
no trunk <T1|T2|T3> lacp
no trunk <T1|T2|T3> interface <port-list>
where
An example is shown next.
• Disable trunk one (T1).
• Disable LACP on trunk three (T3).
• Remove ports one, three, four and five from trunk two (T2).
<ip> <mask> inactive
= Re-enables an IP route with the specified IP address and
subnet mask.
sysname(config)# no ip route 192.168.11.1 255.255.255.0 inactive
<T1|T2|T3>
= Disables the trunk group.
<T1|T2|T3> lacp
= Disables LACP in the trunk group.
<T1|T2|T3> interface
<port-list>
= Removes ports from the trunk group.
sysname(config)# no trunk T1
sysname(config)# no trunk T3 lacp
sysname(config)# no trunk T2 interface 1,3-5