Filter
Top Products
ES-2024 Series User’s Guide
61 Chapter 6 System Status and Port Statistics
6.1.1 Status: Port Details
Click a number in the Port column in the Status screen to display individual port statistics.
Use this screen to check status and detailed performance data about an individual port on the
switch.
Link This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or another
value depending on the uplink module being used) and the duplex (F for full duplex
or H for half duplex).
State If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port (see Section 11.2 on page 95 for more information).
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP.
PD This field is available on ES-2024PWR.
This fields displays whether PoE (Power over Ethernet) is enabled (On) or disabled
(Off) on this port.
LACP This fields displays whether LACP (Link Aggregation Control Protocol) has been
enabled on the port.
TxPkts This field shows the number of transmitted frames on this port.
RxPkts This field shows the number of received frames on this port.
Errors This field shows the number of received errors on this port.
Tx KB/s This field shows the number of kilobytes per second transmitted on this port.
Rx KB/s This field shows the number of kilobytes per second received on this port.
Up Time This field shows the total amount of time in hours, minutes and seconds the port has
been up.
Clear Counter To erase statistical information of a port, select and enter the port number in the Port
field and click Clear Counter.
To erase statistical information of all ports, select Any and click Clear Counter.
Table 6 Status (continued)
LABEL DESCRIPTION