Filter
Top Products
Chapter 35 User/Group
ZyWALL USG 100/200 Series User’s Guide
602
35.4.1 Force User Authentication Policy Add/Edit Screen
Use this screen to specify a condition when users must log in or do not have to log in to the
ZyWALL before their HTTP traffic can pass through the ZyWALL.
Figure 446 Object > User/Group > Setting > Add/Edit
Source This field displays the source address object of traffic to which this condition
applies. It displays any if this condition applies to traffic from all source
addresses.
Destination This field displays the destination address object of traffic to which this
condition applies. It displays any if this condition applies to traffic from all
destination addresses.
Authenticate This field displays whether users must log in (force) or whether users do not
have to log in (skip) when this condition is checked and satisfied.
Add icon This column provides icons to add, edit, move, and remove conditions. It also
provides icons to activate and deactivate conditions.
To add a condition, click the Add icon at the top of the column or next to each
condition. If you click the one at the top of the column, the new condition is first
in the list. If you click the one next to a condition, the new condition appears
right below this condition.
To edit a condition, click the Edit icon at the top of the column or next to each
condition. The Force User Authentication Policy Add/Edit screen appears.
To remove a condition, click on the Remove icon next to the condition. The
web configurator confirms that you want to delete the condition before doing
so.
To move a condition up or down in the list, click on the Move to N icon next to
the condition, and type the line number (# field) where you want to move this
condition. The # field is updated accordingly.
To activate or deactivate a condition, click the Active icon next to the
condition. Make sure you click Apply to save and apply the change.
Apply Click Apply to save the changes.
Reset Click Reset to start configuring this screen again.
Table 196 Object > User/Group > Setting (continued)
LABEL DESCRIPTION