Filter
Top Products
Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
806
AUX Interface
disconnecting failed.
This AUX interface is
not enabled.
The AUX interface is not enabled and a user tried to use the
disconnect aux command.
Please type phone
number of interface
AUX first then dial
again.
A user tried to dial the AUX interface, but the AUX interface does not
have a phone number set.
Please type phone
number of Interface
AUX first then
disconnect again.
The AUX interface does not have a phone number set and a user tried
to use the disconnect aux command.
Interface %s will
reapply because Device
HA become active
status.
Device-ha became active and is using a PPP base interface, the PPP
interface must reapply, %s is the interface name.
Interface %s will
reapply because Device
HA is not running.
Device-ha was deleted and free PPP base interface, PPP interface
must reapply, %s is the interface name.
Interface %s will stop
connect because Device
HA become standby
status.
When device-ha is stand-by and use PPP base interface, PPP
interface connection will stop, %s: interface name.
Create interface %s
has been failed.
When PPP can't running fail, %s: interface name.
Base interface %s is
disabled. Interface %s
is disabled now.
When user disable ethernet, vlan or bridge interface and this interface
is base interface of PPP or virtual interface. PPP and virtual will disable
too. 1st %s is interface name, 2nd %s is interface.
Interface %s has been
changed.
An administrator changed an interface’s configuration. %s: interface
name.
Interface %s has been
added.
An administrator added a new interface. %s: interface name.
Interface %s is
enabled.
An administrator enabled an interface. %s: interface name.
Interface %s is
disabled.
An administrator disabled an interface. %s: interface name.
%s MTU > (%s MTU - 8),
%s may not work
correctly.
An administrator configured a PPP interface, PPP interface MTU >
(base interface MTU - 8), PPP interface may not run correctly because
PPP packets will be fragmented by base interface and the peer will not
receive correct PPP packets. 1st %s: PPP interface name, 2nd %s:
ethernet interface name.
(%s MTU - 8) < %s MTU,
%s may not work
correctly.
An administrator configured ethernet, vlan or bridge and this interface
is base interface of PPP interface. PPP interface MTU > (base
interface MTU - 8), PPP interface may not run correctly because PPP
packets will be fragmented by base interface and peer will not receive
correct PPP packets.1st %s: Ethernet interface name, 2nd %s: PPP
interface name.
Table 301 Interface Logs (continued)
LOG MESSAGE DESCRIPTION