Filter
Top Products
Chapter 44 File Manager
ZyWALL USG 100/200 Series User’s Guide
710
44.3 The Firmware Package Screen
Click Maintenance > File Manager > Firmware Package to open the Firmware Package
screen. Use the Firmware Package screen to check your current firmware version and upload
firmware to the ZyWALL.
" The web configurator is the recommended method for uploading firmware.
You only need to use the command line interface if you need to recover the
firmware. See the CLI Reference Guide for how to determine if you need to
recover the firmware and how to recover it.
Find the firmware package at www.zyxel.com in a file that (usually) uses the system model
name with a .bin extension, for example, “zywall.bin”.
# This column displays the number for each configuration file entry. The total number of
configuration files that you can save depends on the sizes of the configuration files and
the available flash storage space.
File Name This column displays the label that identifies a configuration file.
You cannot delete the following configuration files or change their file names.
The system-default.conf file contains the ZyWALL’s default settings. Select this file
and click Apply to reset all of the ZyWALL settings to the factory defaults. This
configuration file is included when you upload a firmware package.
The startup-config.conf file is the configuration file that the ZyWALL is currently
using. If you make and save changes during your management session, the changes
are applied to this configuration file. The ZyWALL applies configuration changes made
in the web configurator to the configuration file when you click Apply or OK. It applies
configuration changes made via commands when you use the write command.
The lastgood.conf is the most recently used (valid) configuration file that was saved
when the device last restarted. If you upload and apply a configuration file with an error,
you can apply lastgood.conf to return to a valid configuration.
Size This column displays the size (in KB) of a configuration file.
Last Modified This column displays the date and time that the individual configuration files were last
changed or saved.
Upload
Configuration
File
The bottom part of the screen allows you to upload a new or previously saved
configuration file from your computer to your ZyWALL
You cannot upload a configuration file named system-default.conf or lastgood.conf.
If you upload startup-config.conf, it will replace the current configuration and
immediately apply the new settings.
File Path Type in the location of the file you want to upload in this field or click Browse ... to find
it.
Browse... Click Browse... to find the .conf file you want to upload. The configuration file must use
a “.conf” filename extension. You will receive an error message if you try to upload a fie
of a different format. Remember that you must decompress compressed (.zip) files
before you can upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.
Table 249 Maintenance > File Manager > Configuration File (continued)
LABEL DESCRIPTION