Filter
Top Products
28 CHAPTER 4: WINDOWS DRIVERS
10 Select the CD-ROM drives option, clear any other checked options, and
click Next.
The Driver Files Search Results screen appears.
Windows finds the driver on the CD.
11 Click Next.
Files are copied, and then the message “Windows has finished installing the
software for this device” appears.
12 Click Finish.
The software installation is complete. To verify that the installation was successful
Go to: V
erifying Successful Installation.
To change configuration settings
Go to: 3Com DOS Confi
guration Program.
Windows 98 This section describes how to install the network driver and NIC software in a PC
or server running Windows 98.
Before installing the NIC software:
■ Make sure that the NIC is installed in the PC and connected to the network.
■ Make sure that you have the Windows 98 installation files. These files may be
on a CD or diskettes, or they may have been copied to your hard disk when
Windows 98 was installed on your PC.
To install the software:
1 Turn the PC power on.
Windows detects the NIC. The Add New Hardware Wizard starts.
2 Click Next.
The Add New Hardware Wizard screen prompts you to select an option.
3 Select the Search for the best driver for your device (Recommended) option,
and then click Next.
The Add New Hardware Wizard screen prompts you for the driver location.
4 Select the CD-ROM drive option and clear any other check options that
are selected.
5 Insert the EtherCD in the CD-ROM drive, and then click Next.
Windows finds the driver file for the device.
6 Click Next.
Files are copied.
The Insert Disk screen appears, prompting you for the Windows 98 CD-ROM.
NOTE: If you encounter problems during the installation, see TROUBLE.TXT
(located in the HELP directory on the EtherCD) for troubleshooting tips.