Filter
Top Products
82 APPENDIX F: DYNAMICACCESS TECHNOLOGY
Follow this procedure to configure DynamicAccess technology on a local PC:
1 Double-click the 3Com DynamicAccess icon in the Windows Control Panel.
The Traffic Prioritization tab of the DynamicAccess Software Setup screen appears.
2 Select the tab containing the information that you want to configure.
■ Traffic Prioritization—Allows you to prioritize applications, which can
ease bottlenecks in your network and allow critical applications to take
network precedence.
■ Fast IP—Allows you to enable and configure Fast IP.
■ Administration—Allows you to set DynamicAccess technology control panel
access, set VLAN options, enable efficient multicast control, and enable the
prioritizing of multicast traffic.
Removing
DynamicAccess
Technology
To remove DynamicAccess technology from your PC, follow the instructions
appropriate for your operating system.
Windows 95/98 If the 3Com DynamicAccess Control Panel Administration utility is set to Read
Only, you cannot remove the DynamicAccess technology. You must change the
access to Read/Write and then remove DynamicAccess technology.
Follow this procedure to remove DynamicAccess technology from a PC running
Windows 95 or Windows 98:
1 Double-click the Add/Remove Programs icon in the Control Panel.
2 Select the DynamicAccess Technology entry and click Remove.
3 Restart the PC when prompted.
DynamicAccess technology is removed from the PC.
NOTE: For specific instructions on configuring any of the DynamicAccess
technology options, click Help on the 3Com DynamicAccess Technology screen
or access the 3Com World Wide Web site:
http://www
.3com.com/dynamicaccess.
NOTE: Contact your system administrator before you remove DynamicAccess
technology from your PC.
NOTE: Your network connections will break if you select the DA Transport
protocols from either the virtual NIC or the physical NIC and click Remove.