Filter
Top Products
5-55
Security
Encryption – Enable or disable the access point to use data encryption (WEP, TKIP,
or AES). If this option is selected when using static WEP keys, you must configure
at
least one key on the access point and all clients. (Default: Disabled)
Cipher Modes – Selects an encryption method for the global key used for
multicast and broadcast traffic, which is supported by all wireless clients.
AES: AES-CCMP is used as the multicast encryption cipher. AES-CCMP is the
standard encryption cipher required for WPA2.
TKIP: TKIP is used as the multicast encryption cipher.
WEP/TKIP: WEP is used as the multicast encryption cipher. You should select
WEP only when both WPA and WEP clients are supported.
Figure 36 WPA Key Management
WPA Key Management – Specifies the type of WPA encryption to use:
WPA authentication over 802.1x – Requires the use of 802.1x authentication.
WPA Pre-shared Key (PSK) – Requires that 802.1x authentication be disabled.
Key Type – Select the preferred method of entering WEP encryption keys on the
access point and enter up to four keys:
NOTE: You must enable data encryption through the web or CLI in order to enable
all types of encryption (WEP, TKIP, or AES) in the access point.