Filter
Top Products
6-4
CHAPTER 6: COMMAND LINE INTERFACE
Showing Commands
If you enter a “?” at the command prompt, the system will display the first level
of keywords for the current configuration mode (Exec, Global Configuration, or
Interface). You can also display a list of valid keywords for a specific command.
For example, the command “show
?” displays a list of possible show commands:
The command “show interface ?” will display the following information:
Partial Keyword Lookup
If you terminate a partial keyword with a question mark, alternatives that match
the initial letters are provided. (Remember not to leave a space between the
command and question mark.) For example “s?” shows all the keywords starting
with “s.”
Outdoor 11a Building to Building #show ?
APmanagement Show management AP information.
authentication Show Authentication parameters
bootfile Show bootfile name
bridge Show bridge
config System snapshot for tech support
dhcp-relay Show DHCP Relay Configuration
event-log Show event log on console
filters Show filters
hardware Show hardware version
history Display the session history
interface Show interface information
line TTY line information
link-integrity Show link integrity information
logging Show the logging buffers
radius Show radius server
rogue-ap Show Rogue ap Stations
snmp Show snmp configuration
sntp Show sntp configuration
station Show 802.11 station table
system Show system information
version Show system version
Outdoor 11a Building to Building #show
Outdoor 11a Building to Building #show interface ?
ethernet Show Ethernet interface
wireless Show wireless interface
<cr>
Outdoor 11a Building to Building #show interface
Outdoor 11a Building to Building #show s?
snmp sntp station system
Outdoor 11a Building to Building #show s