Filter
Top Products
6-88
CHAPTER 6: COMMAND LINE INTERFACE
Example
WDS Bridge Commands
The commands described in this section are used to set the operation mode for
each access point interface and configure WIreless Distribution System (WDS)
forwarding table settings.
Table 22 WDS Bridge Commands
Outdoor 11a Building to Building #show filters
Protocol Filter Information
=======================================================================
Local Bridge :Traffic among all client STAs blocked
AP Management :ENABLED
Ethernet Type Filter :DISABLED
UPlink Access Table
-----------------------------------------------------------------------
UPlink access control:Enabled
UPlink MAC access control list :
00-12-34-56-78-9a
-----------------------------------------------------------------------
Enabled Protocol Filters
-----------------------------------------------------------------------
No protocol filters are enabled
=======================================================================
Outdoor 11a Building to Building #
Command Function Mode Page
bridge mode Selects Master or Slave mode. IC-W 6-89
bridge role Selects the bridge operation mode for a radio interface IC-W 6-89
bridge channel-auto-sync Automatically finds the parent bridge operating
channel
IC-W 6-90
CAUTION: Do not enable Channel Auto Sync on a master
bridge if there is no root bridge acting as the master
bridge's parent.
bridge-link parent Configures the MAC addresses of the parent bridge
node
IC-W 6-90
bridge-link child Configures MAC addresses of connected child bridge
nodes
IC-W 6-91
bridge dynamic-entry
age-time
Sets the aging time for dynamic entries in the WDS
forwarding table
GC 6-92
show bridge aging-time Displays the current WDS forwarding table aging time Exec 6-94
show bridge filter-entry Displays current entries in the bridge MAC address
table
Exec 6-95
show bridge link Displays current bridge settings for specified interfaces Exec 6-97
!