Filter
Top Products
6-78
CHAPTER 6: COMMAND LINE INTERFACE
Command Mode
Exec
Example
MAC Address Authentication
Use these commands to define MAC authentication on the access point. For local
MAC authentication, first define the default filtering policy using the address filter
default command. Then enter the MAC addresses to be filtered, indicating if they
are allowed or denied. For RADIUS MAC authentication, the MAC addresses and
filtering policy must be configured on the RADIUS server.
Table 20 MAC Address Authentication
Outdoor 11a Building to Building #show authentication
Authentication Information
===========================================================
MAC Authentication Server : DISABLED
MAC Auth Session Timeout Value : 0 min
802.1x supplicant : DISABLED
802.1x supplicant user : EMPTY
802.1x supplicant password : EMPTY
Address Filtering : ALLOWED
System Default : ALLOW addresses not found in filter table.
Filter Table
MAC Address Status
----------------- ----------
00-70-50-cc-99-1a DENIED
00-70-50-cc-99-1b ALLOWED
=========================================================
Outdoor 11a Building to Building (config)#
Command Function Mode Page
address filter default Sets filtering to allow or deny listed addresses GC 6-79
address filter entry Enters a MAC address in the filter table GC 6-79
address filter delete Removes a MAC address from the filter table GC 6-81
mac- authentication server Sets address filtering to be performed with local or
remote options
GC 6-81