Filter
Top Products
6-99
Using the Command Line Interface
Spanning Tree Commands
The commands described in this section are used to set the MAC address table
aging time and spanning tree parameters for both the Ethernet and wireless
interfaces.
Table 23 Bridge Commands
bridge stp enable
This command enables the Spanning Tree Protocol. Use the no form to disable
the Spanning Tree Protocol.
Outdoor 11a Building to Building#show bridge link ethernet
status : Enabled
state : Forwarding
priority : 0
path cost : 19
message age Timer : Inactive
message age : 4346
designated-root : priority = 32768, MAC = 00:30:F1:F0:9A:9C
designated-cost : 0
designated-bridge : priority = 32768, MAC = 00:30:F1:F0:9A:9C
designated-port : priority = 0, port No = 1
forward-transitions : 1
Outdoor 11a Building to Building#
Command Function Mode Page
bridge stp enable Enables the Spanning Tree feature GC 6-99
bridge stp forwarding-delay Configures the spanning tree bridge forward time GC 6-100
bridge stp hello-time Configures the spanning tree bridge hello time GC 6-101
bridge stp max-age Configures the spanning tree bridge maximum age GC 6-101
bridge stp priority Configures the spanning tree bridge priority GC 6-102
bridge-link path-cost Configures the spanning tree path cost of a port IC 6-103
bridge-link port-priority Configures the spanning tree priority of a port IC 6-104
show bridge stp Displays the global spanning tree settings Exec 6-104
show bridge link Displays current bridge settings for specified interfaces Exec 6-97