Filter
Top Products
6-49
Using the Command Line Interface
• host_name - Name of the host. (Range: 1-63 characters)
• community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you define
this string using the snmp-server community command prior to using
the snmp-server host command. (Maximum length: 23 characters)
Default Setting
Host Address: None
Community String: public
Command Mode
Global Configuration
Command Usage
The snmp-server host command is used in conjunction with the
snmp-server enable server command to enable SNMP notifications.
Example
Related Commands
snmp-server enable server (6-48)
snmp-server trap
This command enables the access point to send specific SNMP traps
(i.e.,
notifications). Use the no form to disable specific trap messages.
Syntax
snmp-server trap <trap>
no snmp-server trap <trap>
• trap - One of the following SNMP trap messages:
- dot11InterfaceAFail - The 802.11a or 802.11g interface has failed.
- dot11InterfaceGFail - The 802.11b/g interface has failed.
- dot11StationAssociation - A client station has successfully associated
with the access point.
- dot11StationAuthentication - A client station has been successfully
authenticated.
- dot11StationReAssociation - A client station has successfully
Outdoor 11a Building to Building (config)#snmp-server host 1 10.1.19.23
batman
Outdoor 11a Building to Building (config)#