Filter
Top Products
6-112
CHAPTER 6: COMMAND LINE INTERFACE
interface wireless
This command enters wireless interface configuration mode.
Syntax
interface wireless <a | g>
• a - 802.11a radio interface.
• g - 802.11g radio interface.
Default Setting
None
Command Mode
Global Configuration
Example
To specify the 802.11a interface, enter the following command:
ssid Configures the service set identifier IC-W-VAP 6-126
closed system Opens access to clients without a pre-configured
SSID
IC-W-VAP 6-126
max-association Configures the maximum number of clients that can
be associated with the access point at the same time
IC-W-VAP 6-127
assoc- timeout-interval Configures the idle time interval (when no frames are
sent) after which a client is disassociated from the
VAP interface
IC-W-VAP 6-127
auth- timeout-value Configures the time interval after which clients must
be re-authenticated
IC-W-VAP 6-128
shutdown Disables the wireless interface IC-W-VAP 6-128
show interface wireless Shows the status for the wireless interface Exec 6-129
show station Shows the wireless clients associated with the access
point
Exec 6-133
Outdoor 11a Building to Building (config)#interface wireless a
Outdoor 11a Building to Building (if-wireless a)#
Command Function Mode Page