Filter
Top Products
5-28
CHAPTER 5: SYSTEM CONFIGURATION
Restore Factory Settings – Click the Restore button in the user interface to reset
the configuration settings for the access point to the factory defaults and reboot
the system. Note that all user configured information will be lost. You will have to
re-enter the default user name (admin) to re-gain management access to this
device.
Reboot Access Point – Click the Reset button in the user interface to reboot the
system.
WDS AND SPANNING TREE SETTINGS
Each access point radio interface can be configured to operate in a bridge or
repeater mode, which allows it to forward traffic directly to other access point
units. To set up bridge links between access point units, you must configure the
wireless Distribution System (WDS) forwarding table by specifying the wireless
MAC address of all units to which you want to forward traffic. Up to six WDS
bridge or repeater links can be specified for each unit in the wireless bridge
network.
The Spanning Tree Protocol (STP) can be used to detect and disable network
loops, and to provide backup links between bridges. This allows a wireless bridge
to interact with other bridging devices (that is, an STP-compliant switch, bridge or
router) in your network to ensure that only one route exists between any two
stations on the network, and provide backup links which automatically take over
when a primary link goes down.
NOTE: If you have upgraded system software, then you must reboot the access
point to implement the new operation code. New software that is incompatible
with the current configuration automatically restores the access point to default
values when first activated after a reboot.