Filter
Top Products
Set Up Your System 3
Agilent E6474A User’s Guide 69
4 Connect the short RX Loop cable (E7450-60001) to the RX
LOOP IN port of Receiver 1.
5 Connect the opposite end of the cable to the RX LOOP OUT port
of Receiver 2.
6 Connect the long RX Loop cable (E7450-60002) to the RX LOOP
IN port of Receiver 2.
7 Connect the opposite end of the cable to the RX LOOP OUT port
of Receiver 1.
8 Connect the receiver antennas to the RF INPUT connectors of
the receivers.
9 If equipped, connect the GPS antennas to the GPS ANTENNA
connectors of the receivers.
Dual receiver backpack final assembly
1 Place the component platform inside the backpack, as shown
in Figure 34 on page 68. It attaches to the backpack with
Velcro fasteners.
2 Connect one phone interface cable to the (Phone 1)
port of the Direct Connect Hub.
3 Connect the second phone interface cable to the
(Phone 2) port of the Direct Connect Hub.
4 Connect the headset cables (E6473-60017) to the connectors
of the Direct Connect Hub.
5 Attach the clip-on receiver antennas to the antenna loops on
the sides of the backpack. See Figure 35.