Filter
Top Products
Configuring IS-IS Configuring IS-IS
page 3-30 OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007
Configuring Router Capabilities
The following table lists various commands that can be useful in tailoring a router’s performance capabili-
ties. All the listed parameters have defaults that are acceptable for running an IS-IS network.
To set the IS-IS router to operate in overload state, enter:
-> ip isis overload timeout 70
To configure the router to be in the overload state, enter:
-> ip isis overload-on-boot timeout 80
To enable the adjacency check configuration, enter:
-> ip isis strict-adjacency-check enable
ip isis overload Sets the IS-IS router to operate in the overload state.
ip isis overload-on-boot Configures the router to be in the overload state.
ip isis strict-adjacency-check Enables or disables the adjacency check configuration.