Filter
Top Products
PIM Defaults Configuring PIM
page 7-4 OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007
PIM Defaults
The following table lists the defaults for PIM configuration:
Parameter Description Command Default Value/Comments
PIM status ip load pim Disabled
PIM load status - sparse mode ip pim sparse status Disabled
PIM load status - dense mode ip pim dense status Disabled
Priority ip pim ssm group Disabled
Priority ip pim dense group Disabled
C-BSR mask length ip pim cbsr 30 bits
Priority ip pim cbsr 64
Static RP configuration ip pim static-rp Disabled
Priority ip pim candidate-rp 192
C-RP advertisements ip pim candidate-rp 60 seconds
RP threshold ip pim rp-threshold 1
Keepalive timer ip pim keepalive-period 210 seconds
Maximum RP routers allowed ip pim max-rps 32
Probe timer ip pim probe-time 5 seconds
Register checksum value ip pim register checksum header
Register suppression timer ip pim register-suppress-timeout 60 seconds
Source, group data timeout ip pim keepalive-period 210 seconds
Switchover to Shortest Path Tree
(SPT)
ip pim spt status Enabled
Successive state refresh interval ip pim state-refresh-interval 60 seconds
State refresh message limit ip pim state-refresh-limit 0
State refresh ttl ip pim state-refresh-ttl 16
Hello interval ip pim interface 30 seconds
Triggered hello ip pim interface 5 seconds
Join/Prune interval ip pim interface 60 seconds
Hello holdtime ip pim interface 105 seconds
Join/Prune holdtime ip pim interface 210 seconds
Prune delay ip pim interface 500 milliseconds
Override interval ip pim interface 2500 milliseconds
Designated Router Priority ip pim interface 1
Prune limit interval ip pim interface 60 seconds
Graft retry interval ip pim interface 3 seconds
Stub ip pim interface Disabled