Alcatel-Lucent 6850 Switch User Manual


 
Configuring OSPFv3 Configuring OSPFv3
OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007 page 2-23
To remove a route map redistribution configuration, use the no form of the ipv6 redist command. For
example:
-> no ipv6 redist ospf into rip route-map ospf-to-rip
Use the show ipv6 redist command to verify the redistribution configuration:
-> show ipv6 redist
Source Destination
Protocol Protocol Status Route Map
------------+------------+---------+--------------------
localIPv6 RIPng Enabled ipv6rm
OSPFv3 RIPng Enabled ospf-to-rip
Configuring the Administrative Status of the Route Map Redistribution
The administrative status of a route map redistribution configuration is enabled by default. To change the
administrative status, use the status parameter with the ipv6 redist command. For example, the following
command disables the redistribution administrative status for the specified route map:
-> ipv6 redist ospf into rip route-map ospf-to-rip status disable
The following command example enables the administrative status:
-> ipv6 redist ospf into rip route-map ospf-to-rip status enable
Route Map Redistribution Example
The following example configures the redistribution of OSPFv3 routes into a RIPng network using a route
map (ospf-to-rip) to filter specific routes:
-> ip route-map ospf-to-rip sequence-number 10 action deny
-> ip route-map ospf-to-rip sequence-number 10 match tag 5
-> ip route-map ospf-to-rip sequence-number 10 match route-type external type2
-> ip route-map ospf-to-rip sequence-number 20 action permit
-> ip route-map ospf-to-rip sequence-number 20 match ipv6-interface intf_ospf
-> ip route-map ospf-to-rip sequence-number 20 set metric 255
->ip route-map ospf-to-rip sequence-number 30 action permit
->ip route-map ospf-to-rip sequence-number 30 set tag 8
-> ipv6 redist ospf into rip route-map ospf-to-rip
The resulting ospf-to-rip route map redistribution configuration does the following
Denies the redistribution of Type 2 external OSPF routes with a tag set to five.
Redistributes into RIPng all routes learned on the intf_ospf interface and sets the metric for such routes
to 255.
Redistributes into RIPng all other routes (those not processed by sequence 10 or 20) and sets the tag for
such routes to eight.