Filter
Top Products
Verifying the DVMRP Configuration Configuring DVMRP
page 6-18 OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007
Verifying the DVMRP Configuration
A summary of the show commands used for verifying the DVMRP configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch CLI
Reference Guide.
show ip dvmrp Displays global DVMRP parameters such as admin status, flash interval
value, graft timeout value, neighbor interval value, subordinate neighbor
status, number of routes, number of routes reachable, etc.
show ip dvmrp interface Displays the DVMRP interface table, which lists all multicast-capable
interfaces.
show ip dvmrp neighbor Displays the DVMRP neighbor table, which lists adjacent DVMRP
routers.
show ip dvmrp nexthop Displays the DVMRP next hop entries table. The next hop entries table
lists which VLANs will receive traffic forwarded from a designated
multicast source. The table also lists whether a VLAN is considered a
DVMRP branch or leaf for the multicast traffic (i.e., its hop type).
show ip dvmrp prune Displays the prune table. Each entry in the prune table lists a pruned
branch of the multicast delivery tree and includes the time interval
remaining before the current prune state expires.
show ip dvmrp route Displays the DVMRP routes that are being advertised to other routers in
Route Report messages.
show ip dvmrp tunnel Displays DVMRP tunnels. This command lists DVMRP tunnel inter-
faces, including both active and inactive tunnels.