Filter
Top Products
Configuring OSPFv3 OSPFv3 Quick Steps
OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007 page 2-5
9 You can now display the router OSPFv3 settings by using the show ipv6 ospf command. The output
generated is similar to the following:
10 You can display OSPFv3 area settings using the show ipv6 ospf area command. For example:
-> show ipv6 ospf
Status = Enabled,
Router ID = 5.5.5.5,
# Areas = 2,
# Interfaces = 4,
Area Border Router = Yes,
AS Border Router = No,
External Route Tag = 0,
SPF Hold (seconds) = 10,
SPF Delay (seconds) = 5,
MTU checking = Enabled,
# SPF calculations performed = 3,
Last SPF run (seconds ago) = N/A,
# of neighbors that are in:
Full state = 3,
Loading state = 0,
Exchange state = 0,
Exstart state = 0,
2way state = 0,
Init state = 0,
Attempt state = 0,
Down state = 0
Router ID
As set in Step 5
-> show ipv6 ospf area
Stub Number of
Area ID Type Metric Interfaces
---------------+-------+------+------------------------
0.0.0.0 Normal NA 2
0.0.0.1 Normal NA 2
Area ID
As set in Step 6