Alcatel-Lucent 6850 Switch User Manual


 
OSPFv3 Quick Steps Configuring OSPFv3
page 2-6 OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007
11 You can display OSPFv3 interface settings using the show ipv6 ospf interface command.
For example:
-> show ipv6 ospf interface test
Name = test
Type = BROADCAST,
Admin Status = Enabled,
IPv6 Interface Status = Up,
Oper Status = Up,
State = DR,
Area = 0.0.0.0,
Priority = 100,
Cost = 1,
Designated Router = 3.3.3.3,
Backup Designated Router = 0.0.0.0,
Hello Interval = 1,
Router Dead Interval = 4,
Retransmit Interval = 5,
Transit Delay = 1,
Ifindex = 17,
IPv6 'ifindex' = 2071,
MTU = 1500,
# of attached neighbors = 0,
Globally reachable prefix #0 = 2071::2/64
Area ID
As set in Step 6