Filter
Top Products
Configuring OSPF Verifying OSPF Configuration
OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007 page 1-39
Verifying OSPF Configuration
To display information about areas, interfaces, virtual links, redistribution, or OPSF in general, use the
show commands listed in the following table:
For more information about the resulting displays form these commands, see the “OSPF Commands”
chapter in the OmniSwitch CLI Reference Guide.
Examples of the show ip ospf, show ip ospf area, and show ip ospf interface command outputs are given
in the section “OSPF Quick Steps” on page 1-4.
show ip ospf Displays OSPF status and general configuration parameters.
show ip ospf border-routers Displays information regarding all or specified border routers.
show ip ospf ext-lsdb Displays external Link State Advertisements from the areas to which the
router is attached.
show ip ospf host Displays information on directly attached hosts.
show ip ospf lsdb Displays LSAs in the Link State Database associated with each area.
show ip ospf neighbor Displays information on OSPF non-virtual neighbor routers.
show ip redist Displays the route map redistribution configuration.
show ip ospf routes Displays OSPF routes known to the router.
show ip ospf virtual-link Displays virtual link information.
show ip ospf virtual-neighbor Displays OSPF virtual neighbors.
show ip ospf area Displays either all OSPF areas, or a specified OSPF area.
show ip ospf area range Displays all or specified configured area address range summaries for
the given area.
show ip ospf area stub Displays stub area status.
show ip ospf interface Displays OSPF interface information.
show ip ospf restart Displays the OSPF graceful restart related configuration and status.