Filter
Top Products
Verifying OSPFv3 Configuration Configuring OSPFv3
page 2-30 OmniSwitch 6800/6850/9000 Advanced Routing Configuration Guide December 2007
Verifying OSPFv3 Configuration
To display information about areas, interfaces, virtual links, redistribution, or OPSFv3 in general, use the
show commands listed in the following table:
For more information about the resulting displays from these commands, see the “OSPFv3 Commands”
chapter in the OmniSwitch CLI Reference Guide.
Examples of the show ipv6 ospf, show ipv6 ospf area, and show ipv6 ospf interface command outputs
are given in the section “OSPFv3 Quick Steps” on page 2-4.
show ipv6 ospf Displays the OSPFv3 status and general configuration parameters.
show ipv6 redist Displays the route map redistribution configuration.
show ipv6 ospf border-routers Displays information regarding all or specified border routers.
show ipv6 ospf host Displays information on directly attached hosts.
show ipv6 ospf lsdb Displays LSAs in the LSDB associated with each area.
show ipv6 ospf neighbor Displays information on OSPFv3 non-virtual neighbors.
show ipv6 ospf routes Displays the OSPFv3 routes known to the router.
show ipv6 ospf virtual-link Displays virtual link information.
show ipv6 ospf area Displays either all OSPFv3 areas, or a specified OSPFv3 area.
show ipv6 ospf interface Displays OSPFv3 interface information.